full bridge gate drivers

Hello all, I am trying to build a hardware setup for a PEC9 inverter. Since it has more switches and a different configuration than a regular half/full bridge (meaning no high and low side), I didn't know how to connect the gate driver's power side pins (VDD/VSS) since usually in a half-bridge...

I have made a full-bridge inverter using the IR2110 IC. The MOSFETs used are IRF540n. The bootstrap capacitor is 4.7uf. The diodes used are 1N5819 high-frequency Schottky diodes. The operating frequency is 50KHz. The input signal is given using an Arduino Uno. 1.5kohm gate to source resistor is...

I want to use the H-Bridge module shown in the attachment as a switch in a 12V DC circuit and would prefer if possible, for ease and simplicity, to use a full bridge gate driver such as the IRS2453DS [Data Sheet attached]. The H-Bridge comprises 4 IGBTs, rated for 75A, and the intention is for...