altium

I am a complete beginner, but I would like to learn how to use Altium Designer. Sorry in advance for the silly questions. I have the following two circuits (pic no. 1) that I want to combine into one circuit and draw in Altium Designer schematic. I tried to draw the mentioned circuit in Altium...

I am designing a planar transformer in Altium. I am using the planarTX plug-in I found on GitHub which is helping things move along a lot faster - however it only has the capability of creating spirals in a single direction. This means it is not feasible for creation of a series connected...

I have used PCA9615 differential I2C bus driver in one design to extend the I2C bus over CAT5 cable. (datasheet https://www.nxp.com/docs/en/data-sheet/PCA9615.pdf) The design has been done according to the datasheet recommendation and with the help of a reference design of a popular open-source...

Dear All, I’m using Hyperlynx (MentorGraphic) for Signal Integrity test for PCIE GEN 1 Tx Rx & Clk signals. I imported Altium designed layout file to Hyperlynx. This signals (Tx, Rx, Clk) don’t pass S – Parameters when I run Serdes Batch Wizard. But it pass Channel Verification. 1) What are...