adapter

I am attempting to use a vintage Keithley 610C electrometer and want to make sure I'm using the proper adapter to get from the UHF input to my triax cable that has a BNC connector. My triax cable is the Triax (M), 3 Lug To 3 Alligator Clips...

Hello everyone, I have several industrial board powered by 24v dc that control valves using double magnets with 24V to turn the valve in ON and OFF state with impulses as the valve retain the position. During the decades a new model have been created that control similar valve using coils...

Hello, I had an old AC adapter (230V AC to 14V DC). There was a small part where the insulation of the cable was damaged. You could see the copper coming through. So, I cut the damaged part away, soldered the wires back together, and insulated them with heat shrinks. However, when I then tested...

Good day: Does this seem correct to you? it's just going to be an adapter between a 10 pin aldl diagnostic port and obd2 diagnostic port. Thanks