Hi.
When the IC is alone without nothing, there is still resistance between pin 1 and pin 2.
how can i disable this resistance?
its problem because its permanent switch anything Im connecting to it...
As AG stated, it it used to pass high impedance signals, not power. This means the load resistance should be much higher than the switch resistance so the signal is not significantly affected.
But how can i set the resistance to 0 ?
I Need this for this:
i have simple 9V battery with resistor that power led.
and between the Battery - and the LED -, I have no connection, here comes the CD4066 that should close the circuit for few seconds and stop...
but its have contiuous power because this problem...
sorry my bad english again...
Please help....
When you look at the datasheet, the ON resistance at 10 Volts powersupply is 180 Ohms.
This can not be made lower, as it is the typical resistance of the fets inside the 4066.
You might use a power MOSFET instead of the 4066. The source terminal would have to be connected to ground, the gate to the Q output of the 555, and the drain to the remaining connection.
What is the purpose of this circuit? How much current does the load require?
But your schematic shows pin 7 connected to ground so how can it be +3.75V?
Where is the 5V input? Do you mean that you changed the power supply to +5V?
With a +5V power supply, a 555 has an output high voltage of +3.75V which is normal and is high enough to turn on the CD4066.
We do not know the function of your CD4066 because you do not show its switch contacts connected to anything. You also did not say what they will connect to.
sn74cb3q3125 from TI has on resistance of 5 ohms, but it is in a teeny-tiny package with 0.625mm pitch.
But I agree with others that if you posted the rest of the circuit, that is the part that needs to be switched, our help will be much more useful. Without that this is just stabbing in the dark combined with pulling answers from you.
Look, its only a bluetooth device, its power up by switch,
so its just 2 pins that i need to short.
any ohm will power up the device, that why i need it will not have any ohm...
sorry for my bad english