Any obvious errors in this schematic?

Thread Starter

tracecom

Joined Apr 16, 2010
3,944
I breadboarded the LED flasher circuit from page 8 of Mims Circuit Scrapbook, V. 2, as shown below; I used a new 9v Duracell. It worked, and I walked away for about 10 minutes, and when I returned, the LED was no longer flashing, so I put in another LED. Same result, but not believing my eyes, I tried a third LED and watched. It started off flashing at what looked to be a normal brightness, but quickly got dimmer and dimmer. Now, it's almost imperceptible. Admittedly, these are bulk Chinese LED's, but still...
 

Attachments

Jony130

Joined Feb 17, 2009
5,601
I breadboarded the LED flasher circuit from page 8 of Mims Circuit Scrapbook, V. 2, as shown below; I used a new 9v Duracell. It worked, and I walked away for about 10 minutes, and when I returned, the LED was no longer flashing, so I put in another LED. Same result, but not believing my eyes, I tried a third LED and watched. It started off flashing at what looked to be a normal brightness, but quickly got dimmer and dimmer. Now, it's almost imperceptible. Admittedly, these are bulk Chinese LED's, but still...
In this case LED is not guilty. You need add a resistor in series with the led.
 

Thread Starter

tracecom

Joined Apr 16, 2010
3,944
In this case LED is not guilty. You need add a resistor in series with the led.
I was about to say the same, you can not run a LED without a resistor, ever. You burned yours out.
I wasn't blaming the LED's; I was blaming the schematic. I know that the current must be limited to an LED, but I thought that Mims knew more than I did. In fact, I actually did try the circuit with a 1 kΩ resistor in series with the LED. The LED lit, but it didn't flash. :confused: I had to drop the series resistor to 125 Ω in order for a green LED to flash. With a 9.4 V supply, that's more than 50 mA through the LED, albeit in very short pulses.
 
Last edited:

Thread Starter

tracecom

Joined Apr 16, 2010
3,944
In the original circuit attached to post 1 of this thread, I can get it to oscillate if I change R1 to 10 Ω and R4 to 120 Ω. It's not terribly loud, and the waveform is quite ugly, but it oscillates and R5 does control the frequency.
 
Thread starter Similar threads Forum Replies Date
Schluppy Analog & Mixed-Signal Design 12
Top