Xbee module configuration

Status
Not open for further replies.

Thread Starter

st98

Joined May 27, 2010
33
Hi,

I am currently trying to develop a telemetry wireless system to transmit serial data from an ecu to my pc. I have obtain two xbee pro 868 modules and the xbee explorer serial to set one as transmitter and the second one as receiver. I also have downloaded the X CTU software to configure the modules. Any ideas how to set them up and does anyone know if I need a unit with a UART between the control unit and the module or can I just use the explorer for that? I am just wondering if the data send from the ecu will be read from the transmitter module. Any help would be much appreciated. Thank you in advance.

Regards
 

Wendy

Joined Mar 24, 2008
23,408
The All About Circuits forum Administrative Team has elected not to host discussions of automotive electrical system modifications/enhancements due to safety concerns, the potential of legal ramifications and the possible circumvention of vehicle regulations at the state and federal level.

This thread is against the AAC forum rules, Chapter 6, as seen here:

http://www.allaboutcircuits.com/l_tos.html


Automotive modifications of any kind are strictly forbidden. Therefore, this thread will be closed.

Please try to understand the reasons behind this action, and feel free to browse and use the forums.

You might find answers to your questions in one of these forums:

http://forum.allaboutcircuits.com/sh...ad.php?t=54400
 
Status
Not open for further replies.
Top