the first diagram is connected to a three terminal microphone but we were able to find a two terminal microphone only,, will our connection be alright?
will this connection for the microphone okay?
- Thread starter kirayamato_143
- Start date
Yes that's is okay. However, you may need an RC filter in the V supply (of either circuit) between the 2K2 and 22K resistors. This will ensure that amplifier signal, that has gotten into the supply rail, will not feedback into the amplifier input via the mic bias circuit and cause oscillations.
Regards,
Ifixit
thanks Ifixit noted your response
| Thread starter | Similar threads | Forum | Replies | Date |
|---|---|---|---|---|
| Y | stability feedback connection physics | Analog & Mixed-Signal Design | 5 | |
| M | car ECU data connection | Automotive Electronics | 2 | |
| B | LI Battery connection | General Electronics Chat | 22 | |
| G | speaker connection 8 ohm | Analog & Mixed-Signal Design | 10 | |
| J | Split microphone connection to share it | General Electronics Chat | 7 |
