All About Circuits

What are the physical dimensionl specifications a of ¼W 5% resistor

M

MisterBill2

Joined Jan 23, 2018
18,461
I allow at least 3/8 inch between the two lead holes when I design a circuit board , much more for the higher rated ones, but I often use a larger spacing to jump over a number of traces on the circuit board. I seldom pay much attention to the overall length as we never had those huge production runs. @0 units of anything was a very large order for our group.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
J Add Physical Momentary Push Button Switches to SONOFF 4CHPRO DC Motor General Electronics Chat 3
Hyperion0 Recommendations for Physical books Homework Help 4
levi_ackerman MCU RTU physical architecture Analog & Mixed-Signal Design 0
DonBradman Arduino pin getting input with just a physical touch Microcontrollers 17
P find open source physical design projects IC Design 3
Similar threads
Add Physical Momentary Push Button Switches to SONOFF 4CHPRO DC Motor
Recommendations for Physical books
MCU RTU physical architecture
Arduino pin getting input with just a physical touch
find open source physical design projects

You May Also Like

Top