weslo sl20 treadmill

Thread Starter

dsmithss66

Joined Jan 22, 2012
1
I have a mc60 controller board the control center works the incline goes up and down. all the leds works as they are supposed to I have hooked up a 12v source for the motor and it runs I check the voltage on the output to the motor with the motor disconnected I get around 57.0 volts and when I hook up the motor the voltage goes away pretty sure the motor is not bad and took the choke transformer out of the circuit motor will still not turn did find one resistor that was broke r15 47k replaced it still not luck. I am thinking it something wrong with the mc60 controller.
 

mik3

Joined Feb 4, 2008
4,843
It can be the capacitor after the rectifier. I think there is a rectifier for converting AC mains into DC.
 
Top