Hi all, hope everyone is OK
I think this has been asked at nauseam and I have done my utmost best to trawl through what I can find.
I have a 24V 200W peltier which I wish to use to cool or heat a very small amount of water, circa 2-3L
I have a 12V 100w fan with a heatsink and I have a huge heatsink and another fan.
i also have an aluminium and a copper cooling block (not entirely sure on how to incorporate these either)
Im not entirely sure how I should be approaching this…my current logic is if I seal the huge heatsink in the water (plastic container) with the peltier on the outside and attach the fan to that and power peltier through two channels of a 4 channel SPST relay, I should be able to reverse the polarity and have the peltier transfer heat to the water via the inner heatsink.
Will this even work?
I want to connect the relay to an arduino and have a temperature sensor in the water with a few buttons in order to select the temp and start the heating or cooling cycle to desired temp.
Please bear with me as I am a noob and will require some explaining to akin to a schoolchild
I hope this makes sense. I would highly appreciate any pointers anybody can give me and thank you all in advance
I think this has been asked at nauseam and I have done my utmost best to trawl through what I can find.
I have a 24V 200W peltier which I wish to use to cool or heat a very small amount of water, circa 2-3L
I have a 12V 100w fan with a heatsink and I have a huge heatsink and another fan.
i also have an aluminium and a copper cooling block (not entirely sure on how to incorporate these either)
Im not entirely sure how I should be approaching this…my current logic is if I seal the huge heatsink in the water (plastic container) with the peltier on the outside and attach the fan to that and power peltier through two channels of a 4 channel SPST relay, I should be able to reverse the polarity and have the peltier transfer heat to the water via the inner heatsink.
Will this even work?
I want to connect the relay to an arduino and have a temperature sensor in the water with a few buttons in order to select the temp and start the heating or cooling cycle to desired temp.
Please bear with me as I am a noob and will require some explaining to akin to a schoolchild
I hope this makes sense. I would highly appreciate any pointers anybody can give me and thank you all in advance