N Thread Starter Nsahar Joined Nov 22, 2011 1 Nov 22, 2011 #1 hello everyone; m new to micro processor so hav a lil bit idea of using keil uvision.i have to make a program to display seven segment display from 0 to FF in keil and proteous..... so plz if possible den help me. Thankyou
hello everyone; m new to micro processor so hav a lil bit idea of using keil uvision.i have to make a program to display seven segment display from 0 to FF in keil and proteous..... so plz if possible den help me. Thankyou
Georacer Joined Nov 25, 2009 5,182 Nov 22, 2011 #2 Are you stuck in any particular point? Have you done anything so far? Give us some lead as to where to help you with.
Are you stuck in any particular point? Have you done anything so far? Give us some lead as to where to help you with.
E embedded.anto Joined Nov 23, 2011 9 Nov 23, 2011 #3 use 7447 decoder between 8051 and 7 segment. then send 01 to 09 value by port....... try it. my mail id <snip> for more help mail me Last edited by a moderator: Nov 23, 2011
use 7447 decoder between 8051 and 7 segment. then send 01 to 09 value by port....... try it. my mail id <snip> for more help mail me
E embedded.anto Joined Nov 23, 2011 9 Nov 26, 2011 #4 this is usefull for you Attachments 7 seg.JPG 168.4 KB Views: 44