i'd like to simulate this airmar transducer in ltspice

http://airmar.com/uploads/techdata/200a.pdf

from reading around this forum and other sites it seems i can electrically simulate the transducer using an LCR network of sorts. however, what is not clear to me is all the value's i need to put into ltspice. the data sheet shows some of this, but i don't understand how/which data to pull from the sheet for each of the values. well that's not entirely accurate i understand the series/parallel resistance and capacitance figures, but what value would i use for the inductor?

 

See

 

Thanks. however, when i try to reproduce it, i get.

Error on line 7 : rser= 110 lser= 0.175070437401085 rpar= 1100 cpar= 1.47e-009
Unknown parameter "rpar"
ltra: using linear interpolation because trytocompact option specified
WARNING: Node N002 is floating.
WARNING: Node LSER is floating.

WARNING: Less than two connections to node 110. This node is used by RSER.
WARNING: Less than two connections to node LSER. This node is used by RSER.

i'm sure i've done something wrong, but i don't know what.

 

if i remove the Rser={Rser} Lser={Ls} ... line from the schematic, then the plot runs, but the plot doesn't look like yours. instead of having curves it just looks like an X crossed at 200kHz. and i have dB on the left vs Ohms and on the right i'm at -89 deg

 

You don't know what and where.

 

Thanks, that makes a lot more sense. It wasn't clear to me which component that line was tied to.