Hi all
I would like to make a control relay switch on and off 3 times, once per second, then wait until the circuit is reset before doing the same again.
I have basic electronics skills but not messed with timers etc before
So bacially when energised the circuit should wait 1 second then energise the relay 3 times in 3 seconds then stop untill the circuit is reset by re-powering the circuit.
Any ideas if or how this could be done please?
I can measure the relay resistance if required.
Thanks
Mak
I would like to make a control relay switch on and off 3 times, once per second, then wait until the circuit is reset before doing the same again.
I have basic electronics skills but not messed with timers etc before
So bacially when energised the circuit should wait 1 second then energise the relay 3 times in 3 seconds then stop untill the circuit is reset by re-powering the circuit.
Any ideas if or how this could be done please?
I can measure the relay resistance if required.
Thanks
Mak