Hey all,

I can't believe it took me this long to find this forum!!!

OK here's what I'm trying to do.

I have a 1955 Buick and it has 3 port holes on each fender. I want to be able to use them as turn signals, but I want it to go in order. The closest one to the front turns on fist then the middle and finally the last. Just like the new mustangs rear turn signals.

Can I use 555 ic for this or is there something else I can use?


Tganks

Steve

 

Looks like you will need to keep on searching.

Sorry

http://forum.allaboutcircuits.com/showthread.php?t=53904

Guess it pays to read the TOS before actually posting.

 

The owners of All About Circuits has elected not to host discussions of automotive electrical system modifications/enhancements due to safety concerns, the potential of legal ramifications and the possible circumvention of vehicle regulations at the state and federal level.

This thread is against the AAC forum rules, Chapter 6, as seen here:

6. Restricted topics. The following topics are regularly raised however are considered “off-topic” at all times and will results in Your thread being closed without question:

• Any kind of over-unity devices and systems
• Automotive modifications
• Devices designed to electrocute or shock another person
• LEDs to mains
• Phone jammers
• Rail guns and high-energy projectile devices
• Transformer-less power supplies

This can be found in our Terms of Service (ToS)

Automotive modifications of any kind are strictly forbidden. Therefore, this thread will be closed.

Please try to understand the reasons behind this action, and feel free to browse and use the forums.

You might find answers to your questions in one of these forums:

http://forum.allaboutcircuits.com/showthread.php?t=54400

Another good forum that shares many of the same membership is http://www.electro-tech-online.com/ . Good luck.