Hello,
I have 2 Tsop1738 IR receivers which when used in a usb player ckt, both doesnt seem to respond. So I would like to know if there is any simple way to test them ? I tried giving 3.6v to the vs and grounded pin 1 and tested for a voltage on the output pin, but it always shows a constant voltage whether I use a remote or not. Both are showing the same response. Can I conclude that the TSOP's as blown?
Sorry for making this new thread as there was an existing thread on this forum, but it was stated as a member that he had responded to the thread starter on another forum.
I have 2 Tsop1738 IR receivers which when used in a usb player ckt, both doesnt seem to respond. So I would like to know if there is any simple way to test them ? I tried giving 3.6v to the vs and grounded pin 1 and tested for a voltage on the output pin, but it always shows a constant voltage whether I use a remote or not. Both are showing the same response. Can I conclude that the TSOP's as blown?
Sorry for making this new thread as there was an existing thread on this forum, but it was stated as a member that he had responded to the thread starter on another forum.