stepper motor control using MSP 430...code

Reply to Thread

Discussion in 'Embedded Systems and Microcontrollers' started by subashasc, Oct 12, 2011.

Reply to Thread
  1. Oct 12, 2011 #1
    subashasc

    Thread Starter New Member

    Oct 12, 2011
    1
    0
    Hello guys...i was new to this forum and wondering this could help my project.
    presently i was working on stepper motor speed control using MSP 430 mcu. the input signal will be given using matrix 4x4 keypad and there will be a 7 segment LED display unit to show the speed.

    can any one help me about the code and if some were really interested to work on this project, and can simulate the code i can pay for that as well

    you can contact me at <SNIP>
     
    Last edited by a moderator: Oct 12, 2011
    #1 Reply
Loading...
Related Forum Posts:
  1. mkbutan

    Msp 430

    Posted by mkbutan in forum: General Electronics Chat
    Replies:
    3
    Views:
    1,115
  2. SPQR

    Code for encoder control of stepper motor speed

    Posted by SPQR in forum: Programmer's Corner
    Replies:
    2
    Views:
    6,091
  3. abdulmeeravali

    Msp 430

    Posted by abdulmeeravali in forum: Programmer's Corner
    Replies:
    3
    Views:
    1,426
  4. alistairsam

    manual stepper motor control using cmos discretes

    Posted by alistairsam in forum: General Electronics Chat
    Replies:
    8
    Views:
    3,340
  5. vikalp112singh

    c code for control stepper motor by pc

    Posted by vikalp112singh in forum: The Projects Forum
    Replies:
    1
    Views:
    3,504
You May Also Like:

  1. Comparing Optical Sensors: Understanding D-Star

  2. Raspberry Pi – Setup and Management

  3. Ambient Light Monitor: Understanding and Implementing the ADC


Load More