Hey all. I am building a small practice amp, and I would like to know how to slave a second circuit. I am using a tda2030, and a second one slaved off it for some extra power. Any help is appreciated.

 

Did you see the bridge amplifier configuration schematic in the datasheet? It's on page 6.

If you need more power than shown for the bridged configuration, you need a better amplifier.

 

I am assuming you don't want stereo, but want to create a higher level signal? As in louder?

 

Yes, I saw the bridge application. I'm looking for different levels of power.
No, I'm not looking for stereo. This is a bass amp for use in an apartment