Discussion in 'Electronics Resources' started by B.A. Klim, Mar 25, 2009.

Thread Status:
Not open for further replies.
  1. B.A. Klim

    Thread Starter New Member

    Mar 25, 2009
    I'm building a flashing LED sign for a hot dog stand vendor. But I'm kinda stumped on how to wire the whole thing up. Is there any good sites on the web to help me figure out the best way to write up a schemtic and wire it properly. Basiclly the sign is designed to have a outer ring that flashes, the inner part to read hot dogs while flashing at a different rate then the outer ring, and a price under the words hot dogs flashing at yet another rate (I was thinking of maybe using 7 segment displays for the price). My plan is to run the whole deal with a basic stamp from parallex. What would be the best way to build this and make it run smoothly?
  2. thingmaker3

    Retired Moderator

    May 16, 2005
  3. Wendy


    Mar 24, 2008
    Why early? (being nosey)

    To B.A. Klim:

    If you have any questions keep posting them here, I think you'll find all the help you need. :)
  4. Dave

    Retired Moderator

    Nov 17, 2003
    This is a duplicate thread. Please post replies in the active thread.

Thread Status:
Not open for further replies.