schematic copy past problem due to gnd2 net class With GND

Thread Starter

arslankhan

Joined Jan 23, 2013
5
i am new here ,i was try to copy past a schematic(eagle PCB design software) but there comes an error "dont past due to configutration of net class number/name ".
kindly help m,e out if u can.....::confused:
 

SPQR

Joined Nov 4, 2011
379
Hi,

I don't know Eagle, but by the error message
"don't/cant' paste due to configuration of net class number/name"
if I had to bet, there is a difference in "class number" between the copied schematic and the schematic into which you paste it.

You should look at "class settings" or some other setting to make sure the two schematics are of the same type to Eagle.
 
Top