Hello
I am now using a RS232 to communicate a hand held scanner with a PC, but I don't know what should I do to read the signal from RS232. Do i have to install any software to get the signal? Or It would show automatically?I connected it but the computer did not give any reaction. then I used a 232 analysis program, but it always shown CTS Turned ON/ CTS Turned OFF. what does this mean?
When you are connecting something via RS232, how did you read the signal from computer?what programming you are using?
Thanks!!
I am now using a RS232 to communicate a hand held scanner with a PC, but I don't know what should I do to read the signal from RS232. Do i have to install any software to get the signal? Or It would show automatically?I connected it but the computer did not give any reaction. then I used a 232 analysis program, but it always shown CTS Turned ON/ CTS Turned OFF. what does this mean?
When you are connecting something via RS232, how did you read the signal from computer?what programming you are using?
Thanks!!