Hi All,
Im newbie to RX610 and SPI protocol.
Im using Renesas RX610 Processor as Master in SPI mode and I know that transmission of data from master is on falling edge of SCK(Synchronous clock) and Im using AVR's Attiny2313 as slave device in which data reception should happen at rising edge of SCK.
My question: Is there any provision in RX610 to change the polarity/phase of SCK or is there any alternative solution for the problem.
Thanks in Advance
Im newbie to RX610 and SPI protocol.
Im using Renesas RX610 Processor as Master in SPI mode and I know that transmission of data from master is on falling edge of SCK(Synchronous clock) and Im using AVR's Attiny2313 as slave device in which data reception should happen at rising edge of SCK.
My question: Is there any provision in RX610 to change the polarity/phase of SCK or is there any alternative solution for the problem.
Thanks in Advance
