Hello forum, a bit of an urgent situation here.
I have this installation with a water pump, that should work for at least 2 months, in a way that it gets electricity for 8 seconds than its off for another 8 seconds. After a while it starts to exhaust somehow, the pump is not pushing enough water up, which results in major problems.
I think it has something to do with the engine inside wasn't designed for such use. It's a Barwig 12V waterpump, 18L/min.
I bought in the meantime anther pump that is mechanical, it was ment to be used with a drill. You hook the drill onto the propeller of the pump so the drill can make the pump go. I'm planing to buy an engine that runs this pump and is good with the rapid change of use work,
but this is as far as i got with my skills of solving problems not supported by an electric background knowledge.
I would ask if the forum thinks thinks if I see the problem right and if so, what type of motor or other solution would you recommand?
Thanks
Pán
I have this installation with a water pump, that should work for at least 2 months, in a way that it gets electricity for 8 seconds than its off for another 8 seconds. After a while it starts to exhaust somehow, the pump is not pushing enough water up, which results in major problems.
I think it has something to do with the engine inside wasn't designed for such use. It's a Barwig 12V waterpump, 18L/min.
I bought in the meantime anther pump that is mechanical, it was ment to be used with a drill. You hook the drill onto the propeller of the pump so the drill can make the pump go. I'm planing to buy an engine that runs this pump and is good with the rapid change of use work,
but this is as far as i got with my skills of solving problems not supported by an electric background knowledge.
I would ask if the forum thinks thinks if I see the problem right and if so, what type of motor or other solution would you recommand?
Thanks
Pán