Hey guys, I just have a quick question about steppers if thats ok
Say you have a bi-polar stepper running off 4.6v; quoted as '0.6a/phase (1.2a peak)'...considering that rotation is achieved through applying sequential pulses in sets of 2, when holding, should the motor be drawing 2.3v, 0.3a through each of the 2 energised wires?
So does the '1.2 peak' refer to the maximum amount the device could draw, if each coil was energised, even through the shaft wouldn't turn?
Cheers
Say you have a bi-polar stepper running off 4.6v; quoted as '0.6a/phase (1.2a peak)'...considering that rotation is achieved through applying sequential pulses in sets of 2, when holding, should the motor be drawing 2.3v, 0.3a through each of the 2 energised wires?
So does the '1.2 peak' refer to the maximum amount the device could draw, if each coil was energised, even through the shaft wouldn't turn?
Cheers
