Dear Team,
I am using TMUX1208 in one of my Applications. To avoid any confusion during Power on I am planning to connect pull-down resistor to address
and enable line. The mux is controlled by an Arduino Nano.
Below is my circuit. May I know 10K is fine or not.
Regards
HARI
I am using TMUX1208 in one of my Applications. To avoid any confusion during Power on I am planning to connect pull-down resistor to address
and enable line. The mux is controlled by an Arduino Nano.
Below is my circuit. May I know 10K is fine or not.
Regards
HARI