All About Circuits

PSPICE - Fusible Metal Film Resistor

C

Thread Starter

carouse710

Joined Mar 24, 2013
1
Hi,
Have any one created simulation of pspice for a fusible metal film resistor?

My target is likely below:
Radiated power 0.5W, Maximum Open Voltage 250V, Dielectric withstanding voltage 350V, 2 ohm, tolerance 5%, Temperature Coefficient ±200PPM/℃, Short time overload within ±(1%+0.05Ω)

I don't have much experience on pspice but would like to study from this part for further steps. Thanks a lot.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
dkmnn07 Pspice VCE - IC graph PCB Layout , EDA & Simulations 2
K Hi I have a question reagarding LTspice. I have downloaded the PSpice model from Texas Instruments website for the TPS563257. When opening the .lib fi PCB Layout , EDA & Simulations 3
A Help finding Pspice Model for LT Spice PCB Layout , EDA & Simulations 5
R PSPICE model for a: Voltage controlled Single Pole change over switch PCB Layout , EDA & Simulations 10
K Importing a PSpice model into LTSpice PCB Layout , EDA & Simulations 8
Similar threads
Pspice VCE - IC graph
Hi I have a question reagarding LTspice. I have downloaded the PSpice model from Texas Instruments website for the TPS563257. When opening the .lib fi
Help finding Pspice Model for LT Spice
PSPICE model for a: Voltage controlled Single Pole change over switch
Importing a PSpice model into LTSpice

You May Also Like

Top