Protel Simulation for push pull resonant circuit

Discussion in 'General Electronics Chat' started by ees1, Jan 29, 2008.

  1. ees1

    Thread Starter Active Member

    Jan 7, 2008
    I have a hard time to simulate a push pull resonant circuit. For example if you have different ratio for primary and secondary winding, so you will have different output.
    Does anyone here are good at simulating this kind of particular circuit? I am also interested to know if you also can do transformer saturation analysis by simulation? if you did, what kind of simulation software you using. So far I have tried Protel and Mathlab, and I think Protel is much easier than mathlab.
  2. nanovate

    Distinguished Member

    May 7, 2007
    Have you tried LTSPICE?

    Their Yahoo group is very helpful (and quick responding)