Problem about ESD

Reply to Thread

Discussion in 'General Electronics Chat' started by Inkwaterman, Jan 28, 2005.

Reply to Thread
  1. Jan 28, 2005 #1
    Inkwaterman

    Thread Starter New Member

    Oct 11, 2004
    6
    0
    Hi to everybody!
    I have a problem. <_<
    I use an analog to digital converter for convert a signal from a sensor.
    This sensor is far from the ADC and I must use 4 long wire inside a metallic shield for the connection.
    Sometime an electronic discharge "hit" this metallic shield and my circuit go down.
    I must isolate my circuit from the sensor wire.

    How I can do ?

    I need also to feed the sensor.

    In total I have 4 wire:
    2 wire sensor's signal
    1 wire for +5V
    1 wire for GND

    :blink:
     
    #1 Reply
Loading...
Related Forum Posts:
  1. DanielP

    useful websites about ESD protection

    Posted by DanielP in forum: Electronics Resources
    Replies:
    2
    Views:
    1,093
  2. electronis whiz

    ESD

    Posted by electronis whiz in forum: Off-Topic
    Replies:
    23
    Views:
    3,571
  3. PG1995

    example problem about capacitor

    Posted by PG1995 in forum: General Electronics Chat
    Replies:
    0
    Views:
    874
  4. wolfman0511

    7490 - problem about display....

    Posted by wolfman0511 in forum: The Projects Forum
    Replies:
    1
    Views:
    1,804
  5. Ron R

    Wierd ESD op-amp problem

    Posted by Ron R in forum: The Projects Forum
    Replies:
    3
    Views:
    1,733
You May Also Like:

  1. Improved Interfacing: New ICs for Your Isolated Systems

  2. Coping with Long-Distance Serial Communication: A New Retimer IC from Texas Instruments

  3. Ambient Light Monitor: Zero-Cross Detection


Load More Articles