I have a pair of night vision goggles. All parts check out fine, except for the power transformer capsule.
Input voltage is 3v. I'm unsure about the output, though It's somewhere between 18kv and 22kv.
I highly doubt i'll find a new part for it, so i'm wondering about creating one myself and 3d printing a housing for it.
The only similar thing I can find is 400kv or so on wish and amazon. I'm looking for considerably less current than that though.
I'm no circuit designer, but I certainly understand the concepts, individual components, and can physically assemble them, just looking for a point in the right direction. I'm looking to possibly test at the lower end of the spectrum, and increase if necessary, so as not to blow out the amplifiers.
Input voltage is 3v. I'm unsure about the output, though It's somewhere between 18kv and 22kv.
I highly doubt i'll find a new part for it, so i'm wondering about creating one myself and 3d printing a housing for it.
The only similar thing I can find is 400kv or so on wish and amazon. I'm looking for considerably less current than that though.
I'm no circuit designer, but I certainly understand the concepts, individual components, and can physically assemble them, just looking for a point in the right direction. I'm looking to possibly test at the lower end of the spectrum, and increase if necessary, so as not to blow out the amplifiers.
Attachments
-
55.1 KB Views: 14