Hey guys I'm new here and very uninformed of breadboards, circuits, etc. But the project I'm working on needs to be powered and I need some help.
I need to power 6 40mm fans, 1 water pump, and 2 led strips all 12v.
The fans are rated at 12v .07 A
The pump is 12v .69-1 A
And the LED strips are 12v and not certain of the Amps as they have been cut smaller.
I've purchased a small board to solder all the parts onto, but I'm lost on how to power all these parts, please any help at all would greatly be appreciated! Also a note I'd like to add, I'd like to keep the board as clean and simple as possible. No wires running everywhere, etc
Here are some pictures of what I'm working on and what needs to be wired. If your wondering what it is, its a water-cooling kit
I need to power 6 40mm fans, 1 water pump, and 2 led strips all 12v.
The fans are rated at 12v .07 A
The pump is 12v .69-1 A
And the LED strips are 12v and not certain of the Amps as they have been cut smaller.
I've purchased a small board to solder all the parts onto, but I'm lost on how to power all these parts, please any help at all would greatly be appreciated! Also a note I'd like to add, I'd like to keep the board as clean and simple as possible. No wires running everywhere, etc
Here are some pictures of what I'm working on and what needs to be wired. If your wondering what it is, its a water-cooling kit