plane area and plane area cut out

Discussion in 'The Projects Forum' started by vivek20055, Jan 6, 2013.

  1. vivek20055

    Thread Starter Member

    Nov 4, 2012

    I am new to PADS software. I am designing a four layer board of Induction heating system.

    I have completed logic and placements in layout.

    I need to know what is plane area and plane area cut outs?

    Do I need to assign nets to plane areas before or after routing?

    I have GND and AGND in my design.

    DO I need to assign these nets for different plane areas in GND layer?

    Thanks in advance
    Vivek Alaparthi