PIC controller programming

Discussion in 'General Electronics Chat' started by haroon.ansari97, Mar 11, 2014.

  1. haroon.ansari97

    Thread Starter New Member

    Feb 26, 2014
    Currently i am working in repairing of the display board that used in an elevator . This board consist of some logic gates , regulators , 8-bit shift registers , timer ic and EEPROM/RAM based 8 bit PIC controller PIC16C54
    I detected that this controller is not working but before i order the new controller can any body mention me that if this controller required programming or not because i have no programming tool.
  2. olvine


    Mar 10, 2014
    It definitely need Programming.
    If you are asking to that company,who made that elevator, for replacement then there will be no need of programming that controller.