All About Circuits

OutPut Resistance of a Common-Emitter

J

Thread Starter

Joe24

Joined May 18, 2007
52
Hello all,

I have a problem that has been assinged to me. It is involving a Common-Emitter Amplifier. Please see attached PDF. I have looked over my texts and can't seem to find a way to get started in tackling this problem. Any feedback would be GOLD! Thank you.
 

Attachments

P

pinnacle06

Joined Feb 9, 2007
16
I would start by drawing the small signal model and applying a test voltage source (say Vx) at the output. Then solve for the current generated by the source (Ix) and you can develop the equation from there.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
O How Can I measure MOSFET ro(output resistance), ID(DC current) at LTSpice? PCB Layout , EDA & Simulations 5
Y Output resistance Pspice simulation from MbreakN model Analog & Mixed-Signal Design 5
Brad Selmon reduce RTD resistance output from 1000 ohm to 100 ohm General Electronics Chat 5
Generation The ohmmeter shows wrong output resistance of an optocoupler in Proteus General Electronics Chat 7
M TLVH431 biasing resistance and output voltage calculation ? Power Electronics 4
Similar threads
How Can I measure MOSFET ro(output resistance), ID(DC current) at LTSpice?
Output resistance Pspice simulation from MbreakN model
reduce RTD resistance output from 1000 ohm to 100 ohm
The ohmmeter shows wrong output resistance of an optocoupler in Proteus
TLVH431 biasing resistance and output voltage calculation ?

You May Also Like

Top