I am trying to design a circuit that will take any AC voltage up to 230V. I need my output to always be 24Vdc.
I am using optocouplers to get the change from whatever signal input it is, to the 24V signal. This is shown in the attached circuit. My load is a low active load, so when the opto is turned on, the 24V are taken to ground and gives my load a low signal.
the spec for the optocouplers are attached as well.
I am using the PS2532-2
I am wondering what kind of changes need to be done to my circuit to achieve what I am trying to do. I think I have a pretty decent start/idea, but I would like some direction on what to do now?
Thanks for any help
I am using optocouplers to get the change from whatever signal input it is, to the 24V signal. This is shown in the attached circuit. My load is a low active load, so when the opto is turned on, the 24V are taken to ground and gives my load a low signal.
the spec for the optocouplers are attached as well.
I am using the PS2532-2
I am wondering what kind of changes need to be done to my circuit to achieve what I am trying to do. I think I have a pretty decent start/idea, but I would like some direction on what to do now?
Thanks for any help
Attachments
-
24 KB Views: 349
-
533.2 KB Views: 379