Bought an old Powermatic sander from auction today and sadly noticed it was three-phase after the fact. (My shop only has single phase.) The connector is certainly three phase (twist lock with four prongs) but upon looking at the old motor label, I'm wondering if it could be rewired for single phase? The label reads "1" for "PH." I've tried to decode the model from Marathon's website, but it's a bit confusing. I'm not very knowledgeable about motors, but noticed there were a couple different wiring diagrams on the label. Any ideas if this can be wired for single phase? Pics attached.
Attachments
-
186.9 KB Views: 26