noob needs help LED Strip

Discussion in 'General Electronics Chat' started by monsterfa, Feb 17, 2014.

Thread Status:
Not open for further replies.
  1. monsterfa

    Thread Starter New Member

    Feb 17, 2014
    Ok so what i am trying to do is the following... I am a total noob so please bare with me... I have purchased a 12v led strip that I am wanting to use for my back windshield as signal lights, but I want to put 3 separate strips for each side, that form one solid strip, that blink in sequence and then fade out... kind of like the new mustang... but I want them to blink, fade out, then blink, fade out, then blink and fade out... all in sequence... Then start over again... any help would be greatly appreciated... I have read that a 555 timer is in need? But that's as far as I can understand...
  2. bertus


    Apr 5, 2008

    I am closing this thread as it violates AAC policy and/or safety issues.

    6. Restricted topics.

    The following topics are regularly raised however are considered “off-topic” at all times and will results in Your thread being closed without question:

    • Any kind of over-unity devices and systems
    • Automotive modifications
    • Devices designed to electrocute or shock another person
    • LEDs to mains
    • Phone jammers
    • Rail guns and high-energy projectile devices
    • Transformer-less power supplies
    This comes from our Tos:
    Terms of Service
    There will be enough sites where automotive questions can be discussed :
    Member selected automotive forums

Thread Status:
Not open for further replies.