I'm taking a college electronics course that is currently trying to wire a full-wave rectifier using the Teknikit console 92-300. I wondered if anyone has any experience with them, as whenever my professor and I wire a full wave circuit, the power supply is only allowing for a half wave rectifier.
We do not know if the power supply doesn't allow for the center tap to send power back through, or if there are any tips or tricks regarding the AC power source.

Any information about correctly wiring a full wave rectifier on the Teknikit 92-300 console would be very helpful! Thank you!

 

I have a question.

Did you or your professor check the diodes in the bridge to see if any were open?
One open diode and your bridge becomes a half-wave rectifier.