I have a laptop inverter board that I need a connector unsoldered and soldered to another board. It is just to small for me to mess with. If you are in Texas that would help with shipping. The connector is a 10 pin .5 flat ribbon connector. I will gladly pay a small fee. Thanks Michael

 

Could you post a few pictures to help people decide if they are able to do it or not? I live in the UK so I wouldn't be able to I'm afraid.

 

Thanks here is a couple of shots, I need to take the 10 pin off the green board and put it in place of the 12 pin on the yellow board. Michael

 

looking at your picture the answer is yes as i do this sort of work day in day out butttttt.....i am in the uk.....

 

looking at your picture the answer is yes as i do this sort of work day in day out butttttt.....i am in the uk.....

I wouldn't say I do this work day in day out personally... but I could definitely do it... but same, I'm in the UK

 

Anybody in the states? Thanks Michael

 

Anybody in the states? Thanks Michael

I'm in the states and would be willing/able to do it, but I'm a bit far north, and I expect shipping could be an issue. Up to you, though.

(I'm in Thetford, Vermont, by the way)

Matt

 

have soldering iron and desolder braid will travel for a fee .....