Hello, I am new here. I was not sure where to post this. I'm very happy that I found this site. I adore electronics, and am in University right now with electrical engineering as a major. I have a question about pspice. I made this circuit.http://img339.imageshack.us/img339/4773/cbnqo8.jpg The voltage source is 24cos(20t+45°) volts. I would like pspice to tell me the voltages and currents as it is doing in the above screenshot, but for some reason its giving me 0 everywhere. I used a VAC and have a phase shift of -90 to change it into a cosine. The magnitude I put in is 24 which is not RMS but the actual peak magnitude, but I can fix that. I also tried using a Vsine source where I can enter the frequency f= 20/2pi hz It still gives me zeros everywhere. I am trying to analyze the circuit at steady state, meaning when the transient part dies out.Why is pspice giving me zeros? BTW If I switch the source to a DC source, it gives me correct voltages and currents.I am very new at pspice, can anyone help? Thanks.