OK so I made the stepper driver using the SLA7026 ( the diagram is in the data sheet ) and the stepper details is in the 2nd pdf.
Below is my current circuit
the inputs are active low.
I grounded each input one by one and the motor steps.
So what would I need to run the motor to as Z axis for the drill.
Up and down slowly is what I need.
Any recommendations ?
Below is my current circuit
the inputs are active low.
I grounded each input one by one and the motor steps.
So what would I need to run the motor to as Z axis for the drill.
Up and down slowly is what I need.
Any recommendations ?
Attachments
-
76.8 KB Views: 159
-
146 KB Views: 49