Multitap power transformer
- Thread starter zs1ba
- Start date
Don't hijack someone else's thread. Start a new thread next time.
A mod will come along and move this one.
As Mr. Chips said, a thread belongs to the OP (original poster). Trying to take over someone elses thread is called hijacking, which is not allowed at All About Circuits. I have therefore given you a thread of your very own.
This was split from Power transformer questions
This was split from Power transformer questions
You need to read the markings on the transformer and connect to the 220 VAC terminals. Leave the other terminals free.
Check if certain terminals need to be connected, I believe there may be pairs that need to be in parallel one way for the high, series the low voltage.
| Thread starter | Similar threads | Forum | Replies | Date |
|---|---|---|---|---|
|
Question about pairing 2 power supplies. | General Electronics Chat | 1 | |
| M | Controling output via Vcc on power opamp | Analog & Mixed-Signal Design | 10 | |
| J | Voltage Spike Power? | General Electronics Chat | 15 | |
| R | How to measure power used | General Electronics Chat | 7 | |
| A | Multitap primary transformer Wiring | General Electronics Chat | 11 |
You May Also Like
-
Renesas MCUs/MPUs Can Now Be Programmed With Visual Studio Code
by Aaron Carman
-
IEEE Certifies Li-Fi, the Light-based Communications Standard
by Duane Benson
-
Choosing Inductor Values for Step-Down Switching Voltage Regulators
by Robert Keim
-
Gowin and Andes Team Up on First 22 nm SRAM FPGA With RISC-V Core
by Duane Benson
