Hello,
This is my first post, and I am by no means an electrical engineer. I am working on building a cnc router, and have managed to aquire three stepper motors and drivers. I also managed to get the schematics for these drivers and motors, however it shows how they were hooked up on a previous packaging machine. The drivers state that they have a 75v dc max input, and the motors run on 65vdc. The trick is that they are running off of 110vAC. It looks like the 110vac goes through a bridge rectifier, but that puts out 166vdc (on the multimeter). I need to get this 110vac changed over to 65vdc. Any help would be appreciated.
Thanks,
Jason
This is my first post, and I am by no means an electrical engineer. I am working on building a cnc router, and have managed to aquire three stepper motors and drivers. I also managed to get the schematics for these drivers and motors, however it shows how they were hooked up on a previous packaging machine. The drivers state that they have a 75v dc max input, and the motors run on 65vdc. The trick is that they are running off of 110vAC. It looks like the 110vac goes through a bridge rectifier, but that puts out 166vdc (on the multimeter). I need to get this 110vac changed over to 65vdc. Any help would be appreciated.
Thanks,
Jason