Logic Analyser Query

Discussion in 'General Electronics Chat' started by Sparky49, Dec 13, 2012.

  1. Sparky49

    Thread Starter Well-Known Member

    Jul 16, 2011
    836
    417
    Hi guys.

    I recently won an auction for a HP1650B logic analyser. Let's just say I was suprised to find one which hadn't had a bid, with 20 minutes to go.

    Put a bid on, and with ten minutes to go, still no other bids.

    It ended and I was the only one to put a bid on!

    I don't know how on earth it slipped through the net of other users, but I'm dead chuffed with what I got it for!


    Anyway, I noticed that it appears to have few prongs sticking out of the back, which the pods connect. I don't think this is normal, however I'd like to check with you guys.

    What do you think?

    Thanks for your time,

    Sparky


    P.S. When I opened the box, there were loads of other goodies with it! A HP printer, with spare ink, and a mass of cables. Luck, or what?:D
     
  2. crutschow

    Expert

    Mar 14, 2008
    16,206
    4,331
    The "prongs" may be keying for the pods so the channels are properly assigned.
     
    Sparky49 likes this.
  3. Sparky49

    Thread Starter Well-Known Member

    Jul 16, 2011
    836
    417
    Thank you very much, Crutschow!
     
Loading...