Hello, I am trying to use a PS2501 to help make an H bridge ( using http://www.mcmanis.com/chuck/robotics/tutorial/h-bridge/bjt-circuit.html as a base design )
I am attempting to get one leg of this working first before going on to the rest,
Here is a hand drawing of how I have everything hooked up
If I connect point a to point b my motor turns on, but even though there is power to the diode side of the PS2501-4 it does not turn on through it
Any help would be greatly appriciated, Thank you
Oh one last thing here is a picture of the bread board how It is set up right now
Thank You
Color key
Brown 5v+
Brown/White ground
Orange 12v+
Orange white ground
blue and blue white go to the 2 terminals of the motor
There are 2 green white cords, 1 goes from pin 9 of the PS2501 to ground and the other goes from +12 to the firthest pin on the tip107 ( I beleave it is pin 3 )
https://www.sparkfun.com/datasheets/Components/ps2501.pdf
I am attempting to get one leg of this working first before going on to the rest,
Here is a hand drawing of how I have everything hooked up
If I connect point a to point b my motor turns on, but even though there is power to the diode side of the PS2501-4 it does not turn on through it
Any help would be greatly appriciated, Thank you
Oh one last thing here is a picture of the bread board how It is set up right now
Thank You
Color key
Brown 5v+
Brown/White ground
Orange 12v+
Orange white ground
blue and blue white go to the 2 terminals of the motor
There are 2 green white cords, 1 goes from pin 9 of the PS2501 to ground and the other goes from +12 to the firthest pin on the tip107 ( I beleave it is pin 3 )
https://www.sparkfun.com/datasheets/Components/ps2501.pdf