Hello all you electronic guru's. I'm an inventor and a mechanical engineer so electronics are mystery to me. Check out my web <snip> to see one of my designs
I need assistance to add an intermittent switch/trigger to an existing circuit board. And I'll donate a dollar or 2 for anyone that can help.
I'm using the guts from a 240V AC power drill/engraver with a 170w motor. It has an on/off switch plus a RPM pot. In addition to these I'd like to add a trigger that engages the motor for only 1/5th sec to 1/50 sec. So it will have one mode; When ON the motor is at rest, when a trigger is pressed the motor rotates for a fraction of a second only. Plus I'd like to be able to adjust the time engaged within the rough parameters as mentioned.
Anyone got any suggestions?
Cheers
Ben
I need assistance to add an intermittent switch/trigger to an existing circuit board. And I'll donate a dollar or 2 for anyone that can help.
I'm using the guts from a 240V AC power drill/engraver with a 170w motor. It has an on/off switch plus a RPM pot. In addition to these I'd like to add a trigger that engages the motor for only 1/5th sec to 1/50 sec. So it will have one mode; When ON the motor is at rest, when a trigger is pressed the motor rotates for a fraction of a second only. Plus I'd like to be able to adjust the time engaged within the rough parameters as mentioned.
Anyone got any suggestions?
Cheers
Ben
Last edited by a moderator: