Introduction to All About Circuits Community
Hello to the All About Circuits Community . This is my first post.
My name is Ian ORRELL and am a retired Mechanical Engineering Associate/Technical Teacher and a Vietnam Veteran.
My interests are many. Since I retired in 2002, I don't know how I ever found time to go to work. Has anyone found days with 48 hours ?
I've knocked on Heaven's Door a couple of times and life is too short.
At the moment I am collecting parts for a 10 - 12.5 kW Induction Furnace.
General Information.
1. Incoming Mains Supply 415V 3 phase 59 Hz. 16 mmSq.
2. I have collected some 1000V 75A IGBTs
40 A 3 Phase Bridge Rectifier,
High Current Diodes
High Current SCRs
Refrigeration components for the cooling of the heat sunk electronics and Induction Working Coil and many more smaller components.
3. A foundary friend of mine runs a new commercial 125kW [Cast Iron] and 75 kW [Non Ferrous] Induction Furnace for a Technical College. The operating frequencies vary between 2.5 -3.5 kHz.
Has any one out there built any thing like this, as I would like to contact them ?
Thankyou
Kind Regards
meanu
Hello to the All About Circuits Community . This is my first post.
My name is Ian ORRELL and am a retired Mechanical Engineering Associate/Technical Teacher and a Vietnam Veteran.
My interests are many. Since I retired in 2002, I don't know how I ever found time to go to work. Has anyone found days with 48 hours ?
I've knocked on Heaven's Door a couple of times and life is too short.
At the moment I am collecting parts for a 10 - 12.5 kW Induction Furnace.
General Information.
1. Incoming Mains Supply 415V 3 phase 59 Hz. 16 mmSq.
2. I have collected some 1000V 75A IGBTs
40 A 3 Phase Bridge Rectifier,
High Current Diodes
High Current SCRs
Refrigeration components for the cooling of the heat sunk electronics and Induction Working Coil and many more smaller components.
3. A foundary friend of mine runs a new commercial 125kW [Cast Iron] and 75 kW [Non Ferrous] Induction Furnace for a Technical College. The operating frequencies vary between 2.5 -3.5 kHz.
Has any one out there built any thing like this, as I would like to contact them ?
Thankyou
Kind Regards
meanu
Last edited by a moderator: