Im lost! Looking for Help on Motor controller and Board development

Thread Starter

KarlHanson

Joined Feb 2, 2010
1
Hello All,

I'm developing a energy efficiency product and am at the point where I get Lost.

My product has two motors that have to be controlled;

vacuum motor -120vac/60hz 1.2 amp, need on and off limit control only

actuator motor- 1/64 hp 120vac/60hz time delay and on and off limit control

These are both nothing fancy.

My product also has the need for receiving inputs :

input pressure sensor
output pressure sensor
input temp sensor
output pressure sensor
(I need the board to be programmable to interpolate the T and P sensors to develop differential information, and record if possible and also allow for system to shut down/turn off/and report warnings)

Amp metering sensor
24vpower on and off sensor

(I need the board to be programmable to interpolate the these sensors to record if possible and also allow for system to shut down/turn off/and report warnings)

In conclusion,

I do not know where to go from here! I have many details and a product completed! Except for the controls. and final Contols cost!

Please help I will even give my phone number out to get this complete <snip>

Moderator's note: Please keep questions and answers in the public forum.
 
Last edited by a moderator:
Top