So the idea is that when the PIR sensor is activated through motion, a motor will start to spin and speakers will play music.
The Diagram is a older version and i have now replaced the photodiode/led emitter with a pir pyroelectric sensor. Apart from that everything else is the same.
I have a basic block diagram of all the components needed to make the circuit work, i just don't know how to put it all together (wiring all the connections on a breadboard)
There are two PCB mounted stereo jacks. One connects to the mp3 through a double male 3.5mm jack, the other connects to a speaker. The two PCBs are connected by soldering on the top I presume?
Can someone show me how to connect everything? PS. I am new to electronics and not very good electrical circuits (Cant understand them) can someone show me a diagram to show how i connect what where?
If there is a way to make the circuit without the arduino, i would be open to suggestions.
Thanks.
The Diagram is a older version and i have now replaced the photodiode/led emitter with a pir pyroelectric sensor. Apart from that everything else is the same.
I have a basic block diagram of all the components needed to make the circuit work, i just don't know how to put it all together (wiring all the connections on a breadboard)
There are two PCB mounted stereo jacks. One connects to the mp3 through a double male 3.5mm jack, the other connects to a speaker. The two PCBs are connected by soldering on the top I presume?
Can someone show me how to connect everything? PS. I am new to electronics and not very good electrical circuits (Cant understand them) can someone show me a diagram to show how i connect what where?
If there is a way to make the circuit without the arduino, i would be open to suggestions.
Thanks.
Attachments
-
87.2 KB Views: 60
-
87.3 KB Views: 88