Facebook
Google
GitHub
Linkedin
can anyone advise me how to test the IGBT module-FS450R17KE3,its 6 pack EUPEC/infineon make.
how to test IGBT?
- Thread starter yammy yammy
- Start date
Check for no conduction pin-to-pin on each device. Get a 12 volt battery and attach it to each IGBT in succession - neg terminal to source and pos terminal to the drain through a470 ohm resistor. A meter across the device should show 12 volts. Usa a clip lead to jump +12 to the gate. The meter should show very nearly 0 volts, meaning the IGBT is on.
Repeat for the other IGBT's.
Repeat for the other IGBT's.
| Thread starter | Similar threads | Forum | Replies | Date |
|---|---|---|---|---|
|
Dynamic test for mosfet and IGBT | Test & Measurement | 28 | |
| E | high power igbt test | Power Electronics | 3 | |
|
IGBT device ( test in room lab ) | Test & Measurement | 16 | |
|
IGBT Test Jig | General Electronics Chat | 11 | |
| M | IGBT forward leakage current test | General Electronics Chat | 2 |
