How to Run and programme in MPLAB X using PICKit 3

Discussion in 'Programmer's Corner' started by harami, Apr 7, 2012.

  1. harami

    Thread Starter Member

    Jun 20, 2011
    Im using MPLAB X with C18 compiler, PIC18F4520 microcontroller and a PICKit 3 programmer kit. I got a code written up and i have build and debugged successfully however as this is my first time using these kits, im struggling to programme the code onto my microcontroller. i also have build a circuit so i just need to put the programmed PIC once i programme it.

    another thing is, how do i sumulate or see the outputs using MPLAB X without programming a microcontroller? how can i see an outputs which can prove that my code is is working?
  2. panic mode

    Senior Member

    Oct 10, 2011