Recently I have corrupted my laptop bios So I preferred the hot flash method as I have a desktop with same BIOS series chip. I desolder BIOS chip on both laptop and desktop. But while soldering wires to the desktop BIOS slot, accidentally the wet solder fall on the leads of the ic . I got continuity among that leads. Please help me desoldering it.

 

Ic

 

You can sometimes use a soldering iron with a little solder on it to drag and pull solder bridges off.

A better way is to use solder braid by putting a little solder on the braid and then holding the braid against the IC pins with the side of the soldering iron for the excess solder to be pulled into the braid.

 

Take two 1mm Sq wire u form what fit over the contacts lot of solder and you lift the part of the print.
use braid to clean the lot.

 

I will try and post here

Take two 1mm Sq wire u form what fit over the contacts lot of solder and you lift the part of the print.
use braid to clean the lot.

Hmmmm... Can you draw it and post it here please

 

I will try and post here

Hmmmm... Can you draw it and post it here please

https://en.wikipedia.org/wiki/Desoldering

Solder braid or solder wick
Lay the braid against the solder you want to pick up. Apply heat to the braid. As the solder melts it gets sucked into the braid, flowing following the heat..

 

I second the solder braid method. Also CLEAN your circuit before you post a photo of it - and put LIGHT on your subject.

 

Y

I second the solder braid method. Also CLEAN your circuit before you post a photo of it - and put LIGHT on your subject.

Yup.....